Service and support
for industry

Our strategy is to support our clients on their industrial activities

Process flow
diagram development

Our strategy is to support our clients on their industrial activities

Introduction
of dewatering equipment<

Our strategy is to support our clients on their industrial activities

Complex utilization
of waste

Our strategy is to support our clients on their industrial activities

Resource-Engineering
is a member of chamber of commerce and industry

Official
partners

Resource-Engineering is an accredited agent of the leading manufacturers:

Metallurgy

Ferrous metallurgy

Using chamber filter presses and decanter centrifuges for sludge dewatering of fine blust-furnace, open-hearth and basic oxygen production makes it possible to:

  • use dewatered sludge as a raw material for sintering;
  • use purified water in the working cycle of the enterprise ( with a minimum solids content);
  • stop using tailings ponds (construction costs, maintenance and operation of tailings ponds are quite high);
  • remove tailings ponds from enterprise flowsheet

Non-ferrous metallurgy

Using chamber filter presses and decanter centrifuges for sludge dewatering makes it possible to:

  • use dehydrated sludge as a raw material for re-use in manufacture;
  • stop using tailings pond, to stop the discharge of chemically aggressive materials (especially for aluminum industry);
  • reduce the drying process in autoclaves and tunnel kilns, using pre-dewatering equipment (reduced consumption of electricity and gas spent on drying of raw material).